ledcoms

LED display module color cast solution technology

Looking at the color cast and color of the LED display modules from the side, the displayed colors are inconsistent. What is going on?

The main reasons for the color cast of LED display modules:

1. Problems with LED lights: (including inconsistent chip parameters, defects in packaging glue material, position error during die bonding, error during spectroscopic color separation, etc.), it will affect the luminous wavelength, brightness and angle of the same batch of LED lights. Therefore, the production of LED electronic display has a very important process: mixing lights. Mix all the LED lights of the same color evenly, and then insert them on the PCB. The advantage of this is that it can avoid partial color cast of the LED module.

2. Production process: After the LED module has been wave soldered, the LED position has been fixed, and it should not be moved at this time. However, because many companies do not have the protection conditions, they often collide and bend the LED lights in the process of testing, repairing, soldering pin headers, aging and transferring. Then, the so-called whole line is carried out before the glue is poured, which can easily cause the lights on the LED screen to stagger irregularly, resulting in the color cast of the module.

4. Power supply problem: When designing the LED display, it is impossible to know what kind of material to choose (including the selection and amount of power supply), and there is a problem with the power supply system, which leads to the phenomenon of uneven power supply of the LED module.

5. Control system and control IC: Because LED display manufacturers do not have the design, development, testing and production capabilities of LED display control systems and control ICs. Of course, the display screen produced cannot be guaranteed, and the only thing that can be done is to adjust the parameters.

Therefore, when the color cast of the LED display module is caused by the LED lamp and the production process, the module can only be repaired or replaced. When it is a power supply problem, you need to replace the power lamp, etc. If it is a problem with the control system and IC, you can only ask the manufacturer to repair or solve it.

INDOOR LED SCREEN
INDOOR FINE PITCH
_tmp_jZqb2B2BAJM888P8MVcFAQOZ4 (1)
INDOOR ULTRA SLIM
1000x1000led display
OUTDOOR FRONT SERVICE
RENTAL LED DISPLAY5
OUTDOOR 3D DISPLAY
INDOOR LED RENTAL DISPLAY2
INDOOR RENTAL
OUTDOOR LED RENTAL DISPLAY800
OUTDOOR RENTAL
RENTAL LED DISPLAY
RENTAL LED FLOOR
indoor led floor two
FIXED LED FLOOR
TRANSPARENT LED DISPLAY2
FLEXIBLE LED MESH